The Xiangke DRM-II thermal conductivity tester (non-steady-state plate method) is characterized by its simple structure, high accuracy, and fast testing speed (approximately ten minutes per test). A single test can simultaneously measure the thermal conductivity, thermal diffusivity, and specific heat of homogeneous plate, gel, and powder materials in dry or different moisture content conditions, and it can also measure the thermophysical properties under different moisture content conditions.
Xiangke DRP-Ⅱ thermal conductivity tester (plate steady-state method) uses the steady-state method to measure the thermal conductivity of different materials. Its design is clear, simple, and the experimental method is typical and practical. Thermal conductivity test range: 0.1～300w/m·k, test materials: silicone rubber, bakelite, aluminum, air, etc.
The Xiangke DRL-V hot flow method multifunctional thermal conductivity tester mainly tests the thermal resistance of thin thermal conductors, solid electrical insulating materials, thermal grease, resins, rubbers, beryllium oxide ceramics, and aluminum oxide ceramics, as well as the contact thermal resistance at the solid interface and the thermal conductivity of the materials. With the addition of a high thermal conductivity detection device, it can also test the thermal conductivity of high thermal conductivity materials such as aluminum alloys and the contact thermal resistance between metals and between metals and thermal pads.
The Xiangke DRL-III silicone rubber thermal conductivity tester and thermal resistance tester mainly tests the thermal resistance of thin thermal conductors, solid electrical insulating materials, thermally conductive resins, silicone grease, rubber, beryllium oxide ceramics, and aluminum oxide ceramics, as well as the contact thermal resistance at the solid interface and the thermal conductivity of the materials.
MESSAGE